G290B03A-DAT
Adjustment After Headlight
Assembly Replacement
Horizontal line
Cut-off line
L
H
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
be checked using an aiming screen as
shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis
of light is parallel to centre line of the
body and is aligned with point "P"
shown in the illustration.
2. Dotted lines in the illustration show
the centre of headlights.
SPECIFICATIONS:
"H"
Horizontal centre line of headlights
Vertical line
from ground.
W
: 656 mm
30mm
"W"
Distance between each headlight
"P"
H
centre.
: 1,078 mm
Ground
line
"L"
Distance between the headlights
and the wall that the lights are tested
G290B01A-A
against.
: 3,000 mm
DO-IT-YOURSELF MAINTENANCE
G270A02A-DAT
REPLACEMENT OF BULBS
Before attempting to replace a light
bulb, be sure the switch is turned to the
"OFF" position.
The next paragraph shows how to reach
the light bulbs so they may be changed.
Be sure to replace the burned-out bulb
with one of the same number and watt-
age rating. See page 6-31 for the watt-
age descriptions.
All bulbs are available from your Hyundai
dealers Parts Department.
!
CAUTION:
Keep the lamps out of contact with
petroleum products, such as oil,
gasoline, etc.
9- 21