Hyundai Accent Owner's Manual page 108

Wrench bar
Wheel brace
4. Engage the jack in the position
shown and using the wheel brace,
raising the car until the wheel is
clear of the ground.
NOTE:
The jack should not be used on
anything other than a firm flat base
to prevent sinking or slippage.
5. Remove the wheel nuts and the
road wheel.
!
CAUTION:
Never work underneath the vehicle
D060E03A-D
when it is supported by a jack. The
jack is intended for use when wheel
changing only and no other pur-
pose. When undertaking other
maintenance operations, a suitable
jack and body supports must be
used before any work commences.
Serious personal injury may result
if this warning is ignored.
D060F02A
WHAT TO DO IN AN EMERGENCY
6. Prior to replacing the roadwheel,
ensure that the mating surfaces of
the wheel and the hub are clean.
7. Replace the roadwheel, fit the wheel
nuts, with the tapered end towards
the wheel and tighten.
6- 7
D060G02A
D060H01A