Subscribe to Our Youtube Channel
Related Manuals for National Instruments RS-232
Summary of Contents for National Instruments RS-232
- Page 1 Powered RS-232 2-Port PCI Card User Manual Ver. 1.00 All brand names and trademarks are properties of their respective owners.
-
Page 2: Table Of Contents
Contents: Chapter 1: Introduction ............3 1.1 Product Introduction ............ 3 1.2 Features ................ 4 1.3 System Requirements ..........4 1.4 Package Contents ............4 Chapter 2: Getting Started ..........5 2.1 Hardware Installation ..........5 2.2 Jumper Settings............6 2.3 Driver Installation ............ -
Page 3: Chapter 1: Introduction
Chapter 1: Introduction 1.1 Product Introduction RS-232 I/O series, a line of Universal PCI Multi-port Serial Communication Board, is designed for both 3.3V/5V 32/64-bit PCI Bus with Plug and Play feature. It can be installed in virtually any available PC system and compatible with all major operating systems. -
Page 4: Features
128-bype deep transmit/receive FIFOs Data transfer rate up to 230400bps Optional RS-232 signal or power output to serial device Provides 5VDC or 12VDC power output via pin 1/4/8/9 ±15KV ESD protection on all signal pins ... -
Page 5: Chapter 2: Getting Started
Replace the slot bracket’s holding screw to secure the card. Replace the computer cover and reconnect the power cord. Power for the Powered RS-232 DB9 connectors are supplied from 4-pin connector located on the PCB. This connectors allows a PC... -
Page 6: Jumper Settings
In order to get efficient intake current output, there is one set of 4-pin power connector designed on the board. The 4-pin power set draws both +12VDC and +5VDC power output for powered RS-232 device using. Note: If system’s power supply can not provide the efficient power to serial devices, it will cause your PC system unstable or unexpected reboot. - Page 7 You can read below silkscreen print on the PCB. Each COM port has four jumper settings for the 1/4/8/9 pin for DB9 male connector. You can select standard RS-232 signal (system default), +5VDC, or +12VDC power output on the assigned pin.
- Page 8 COM 1 Port – 4 Normal(DTR) COM 1 Port – 8 Normal(CTS) COM 1 Port – 9 Normal(RI) COM 2 Port – 1 Normal(DCD) MN2000000198 Page 8...
- Page 9 COM 2 Port – 4 Normal(DTR) COM 2 Port – 8 Normal(CTS) COM 2 Port – 9 Normal(RI) Note: System default setting is normal mode, standard RS-232 pin MN2000000198 Page 9...
-
Page 10: Driver Installation
The following screen will show up and please click “Install Driver”. Note: If the install program doesn’t run automatically, please locate and double-click on the Autorun.exe file in the CD to launch the install program. Please click “RS-232 PCI Card” to start the installation. MN2000000198 Page 10... -
Page 11: Installation For Linux 2.4.X/2.6.X
Follow the instructions on screen to install the driver. 2.3.2 Installation for Linux 2.4.x/2.6.x Please refer to the installation guide and driver for Linux 2.4.x & 2.6.x operation system installation within the folder located in the CD driver. :\Driver\PCI\Linux 2.3.3 Installation for Windows CE Please refer to the installation guide and driver for Windows CE 4.2&5.0&6.0 operation system installation within the folder located in the CD driver.
Need help?
Do you have a question about the RS-232 and is the answer not in the manual?
Questions and answers