Clean Hydro Fan Cooling Guards; Clean Debris From Machine; Clean Grass Build-Up Under Deck - Exmark Laser Z Operator's Manual

Maintenance
Clean Hydro Fan Cooling
Guards
Service Interval: Before each use or daily
Removing debris from the hydro fan cooling guards
will allow the hydro system to run cooler and improve
the life of the hydro system.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Slide seat all the way back, then lift the seat to
access the LH and RH hydro drive area.
3. Remove accumulated debris from the hydro fan
cooling guards.

Clean Debris From Machine

Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Clean off any oil, debris, or grass build-up on the
machine and cutting deck, especially under deck
belt shields, around the fuel tank, around engine
and exhaust area.
Clean Grass Build-Up Under
Deck
Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Raise deck to the transport (5 1/2 inch (14 cm)
cutting height) position. Lift the front of unit
and support unit using jack stands or equivalent
support.
CAUTION
Raising the mower deck for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
3. Clean out any grass build-up from underside of
deck and in discharge deflector.
48