Alternate Installations; Alternate Methods Of Securing Drain Hose - Kenmore Washer/dryer 240 Volts Installation Instructions Manual

CORRECT INCORRECT
INCORRECT
CORRECT
Read and save the Operat-
13.
ing Instructions and the Use
and Care Guide that
came with the Laundry Center.
Clean the dryer drum and
14.
washer tub with a damp
cloth.
15.
Turn on electricity at power
source.
Start washer and dryer.
16.
RUN THROUGH ONE
COMPLETE CYCLE and
check for possible leaks, exhaust con-
nections and tub drainage.
17.
Reinstall access panel.

Alternate installations:

recessed or closet
area locations.
The following are minimum installa-
tion spacings and openings (in inches)
that you should allow. For easier
installation and service, consider
additional spacing.
Dryer
Washer
Closet
Door
Side View
Closet
Page 5
Minimum Installation Spacing
RECESS
INSTALLATION A B C D
INSIDE EXHAUST 4 0 4 0
OUTSIDE
EXHAUST 1 0 0 0
CLOSET
INSTALLATION A B C D
OUTSIDE EXHAUST
ONLY 1 0 0 0
When the Laundry Center is installed
in other than the recessed and closet
type of installation shown, minimum
dimensions indicated must be observed.
To prevent large amounts of lint and
moisture from accumulating and to
maintain drying efficiency, this
appliance must be exhausted outdoors.
Non-exhausted installation-only rear
exhaust position permitted.
Alternate methods of
securing drain hose
Put the bent end of the
A.
drain hose in the tub or
standpipe.
Figure 3
The drain hose must be held
B.
securely with the cable tie so
it does not come out
of the standpipe during use.
Figure 4
F G H
F G H
60 60
1
SQ.IN. SQ.IN.
Cable Tie
Cable
Tie