Standby Function; Auto Standby Function; Entering The Standby Mode Manually; Releasing The Standby Mode Manually - Fostex PX-6 Owner's Manual

Standby function

Auto standby function

When the mode select switch is set to VOLUME
or TONE, the auto standby function is enabled.
When the auto standby function is enabled, if
there is no input signal for four hours, the unit au-
tomatically enters the standby mode.
<Note>: Depending on the source noise level or the
connection condition, the auto standby function may
not correctly work.
When the unit is in the standby mode, the
"FOSTEX" logo on the front panel flashes.
<Note>: When the mode select switch is set to OFF,
the auto standby function is disabled.

Entering the standby mode manually

By long-pressing the [CONTROL] knob when the
mode select switch is set to OFF, you can turn
the unit to the standby mode.
This feature would be useful when you go outside
the studio for a while.
Releasing the standby mode
When the unit is in the standby mode, pressing
the [CONTROL] knob releases the standby mode
and returns to the normal condition.

Parameter lock function

When the mode select switch is set to OFF, the
parameter lock function is enabled and the unit is
in the following conditions.
• You cannot change the setting values.
• The auto standby function is disabled.
E-8