Table of Contents
Advertisement
Service settings via software
Submenu
Submenu
Cali-
bration
In this submenu you can sync the transport and sewing feed, or calibrate
thread tension.
Subitem
Feed sync.
In this subitem you can set the synchronous run of the top and bottom
transports.
Check the correct setting
1. Switch off the machine at the main switch.
2. Removing the needle ( Operating instructions Chap. 8.7).
3. Switch on the machine at the main switch.
4. Switch to manual mode ( Operating instructions Chap. 9.4 Manual
5. Press
6. Press
7. Press the numeric key 0 as the fullness.
8. Place 2 identical sheets of cardboard on top of one another on the fabric
9. Press the pedal and observe the cardboard being fed:
If the pieces of cardboard are not aligned, you must synchronize the top
and bottom transport in
Figure 63: Synchronizing the top and bottom transport
Synchronization steps
1. Access technical level ( Chap. 18.2, p. 56).
2. Select the menu item
3. Select the submenu
4. Select the subitem
5. Change the value in this field by pressing
6. Repeat the test with the pieces of cardboard.
7. Repeat steps 1 to 6 if needed.
Service Instructions 650-16 Version 00.0 - Last Updated 09/2012
Calibration
Feed sync.
mode).
to select the parameter
/
to set 0 as the curve support value.
support.
Both pieces must stay aligned.
Feed sync.
+/-
Calibration.
Feed sync.
An input box with a numeric value appears on the right.
• Increase top transport: Increase value
• Reduce top transport: Reduce value
Curve support
in technician level.
2
Service
by pressing
/
.
.
OK
:
68
Advertisement
Table of Contents
