DeLonghi ECAM22.36X Instructions For Use Manual page 20

GROUND TOO FINE ADJUST
MILL
ADD PRE-GROUND COFFEE
DESCALE
REDUCE COFFEE AMOUNT
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
REPLACE FILTER
TURN DIAL TO CLEAN
INSERT WATER SPOUT
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
alternating with...
HOT WATER PRESS OK
NSERT MILK CONTAINER
I
The grinding is too fine and the coffee is deli-
vered too slowly or not at all.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel is clogged.
The infuser has not been replaced after
cleaning.
The tank is not correctly in place.
The inside of the appliance is very dirty.
The water softener filter is exhausted.
Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
The hot water spout is not inserted or is inser-
ted incorrectly.
The water circuit is empty.
The milk container is not inserted correctly.
epeat coffee delivery and turn the grinding
R
adjustment dial (fig. 8) one click clockwise to-
wards "7" while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see the section
"Adjusting the coffee mill" on page 11).
If the problem persists, turn the steam dial to
the I position and let some water run from the
cappuccino maker.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function.
The descaling procedure described in the sec-
tion "Descaling" needs to be performed as soon
as possible (page 16).
Select a milder taste or reduce the quantity of
pre-ground coffee.
Fill the beans container.
Empty the funnel with the help of a brush,
as described in the section "Cleaning the pre-
ground coffee funnel" (page 15).
Insert the infuser as described in the para-
graph "Cleaning the infuser" (page 15).
Insert the tank correctly and press as far as it
will go.
Clean the inside of the appliance thoroughly,
as described in the section "Cleaning" (page
14). If the message is still displayed after
cleaning, contact customer services.
Replace the filter or remove it as described in
the section "Water softener filter" (page 17).
Turn the froth adjustment dial to CLEAN.
Insert the water spout (D3) as far as it will go.
Press OK to deliver water from the spout until it
flows out normally.
Insert the milk container (fig. 13) as far as it
will go.
19