Hotpoint SX 1038L PX Operating Instructions Manual page 13

Left
Right guide
guide rail
rail
B
C
D
on the spacers A.
! Do not place the sliding racks in position 5.
Automatic cleaning with the FAST
CLEAN function
With the FAST CLEAN mode, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated, burning away food and
grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become
very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause
for concern: this process is both normal
and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the
inside of the oven using a damp sponge. Do not
use detergents;
• remove all accessories and the sliding rack kit
(where present);
• do not place tea towels or pot holders over the
oven handle.
! If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
! The programme may only be started once the oven
door has been closed.
To activate the Fast Clean programme:
1. Switch the control panel on by pressing the
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls ( see diagram ).
The holes for the left
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
4. Finally, fit the frames
button.
2. Press the button; the TIME display will show
the default duration of 1:30 h (normal cycle), while he
TEMPERATURE display will show "Piro" and "nor"
alternately;
3. The desired cleaning level can be selected by
pressing the button, then:
+
- pressing to switch to the intensive cycle: the
duration is 2 h and the TEMPERATURE display
shows the text "Piro" and "int" alternately;
-
- pressing to switch to the economy cycle: the
duration is 1 h and the TEMPERATURE display
shows the text "Piro" and "eco" alternately.
Safety devices
• the door locks automatically as soon as the
temperature reaches a high value; the
lights up on the display;
• pressing the button cancels the cleaning
cycle t any time;
• if a malfunction occurs, the heating elements will
be switched off;
• once the oven door has been locked, you cannot
change the duration and end time settings.
Programming delayed automatic cleaning
! Programming is possible only after selecting the
FAST CLEAN mode.
1. Press the button and set the end time using
+ -
the and buttons.
2. Once you have reached the desired end time,
press the button again.
3. Press the button to activate the programmed
mode.
4. When the selected time has elapsed, "END"
appears on the TEMPERATURE display and a
buzzer sounds.
• For example: it is 9:00 a.m. and the Economy
(ECO) FAST CLEAN level has been selected, with
the default duration of 1 hour. 12:30 is scheduled
as the end time. The programme will start
automatically at 11:30 a.m.
The icons and flash to indicate that
programming has taken place. After programming, in
the time before the Fast Clean mode starts, the
TIME display indicates the duration and end of the
Fast Clean mode alternately.
To cancel programming press the
GB
icon
button.
13