Completing The Parts Replacement - Lenovo 10AU User Manual

• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 7 "Using the Setup Utility program" on page 87.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 12 for the locations of various
components in your computer.
2. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
3. Lower the drive bay assembly. See "Accessing the system board components and drives" on page 37.
4. If you have removed the front bezel, reinstall it.
5. Position the computer cover on the chassis so that the rail guides on the computer cover engage the
rails on the chassis. Then, slide the computer cover to the front of the computer until it snaps into
position and is closed. Then, install the two screws to secure the computer cover.
Figure 63. Reinstalling the computer cover
6. If there is a padlock available, lock the computer cover. See "Locking the computer cover" on page 32.
7. If there is a Kensington-style cable lock available, lock the computer. See "Attaching a Kensington-style
cable lock" on page 33.
8. Reconnect the external cables and power cords to the computer. See "Locating connectors on the
rear of your computer" on page 10.
9. To update your configuration, refer to Chapter 7 "Using the Setup Utility program" on page 87.
76
ThinkCentre E73 User Guide