Replacing The Hard Disk Drive - Lenovo 10AU User Manual

The battery normally requires no charging or maintenance throughout its life; however, no battery lasts
forever. If the battery fails, the date, time, and configuration information (including passwords) are lost. An
error message is displayed when you turn on the computer.
Refer to the "Lithium battery notice" in the Safety, Warranty, and Setup Guide for information about replacing
and disposing of the battery.
To replace the battery, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 35.
3. Locate the battery. See "Locating parts on the system board" on page 13.
4. Remove the old battery.
Figure 18. Removing the old battery
5. Install a new battery.
Figure 19. Installing a new battery
6. Reinstall the computer cover and connect the cables. See "Completing the parts replacement" on
page 76.
Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
7. Turn on the computer and all attached devices.
8. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 7 "Using the Setup
Utility program" on page 87.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.

Replacing the hard disk drive

Attention: Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" on page v.
.
Chapter 5 Installing or replacing hardware
43