Interface Manager Card Problems - HP ESL E-Series User Manual

Interface Manager card problems

Table 13
Manager card.
Table 13: Status LED diagnostic codes
On
Blinks 1x per 5
second interval
Blinks 2x per 5
second interval
Blinks 3x per 5
second interval
Blinks 4x per 5
second interval
Off
Table 14: Network link activity/speed LEDs
Link Activity
LED
(left side of
each Ethernet
port)
Link Speed LED
(right side of
each Ethernet
port)
ESL E-Series Tape Library User's Guide
and Table 14 describe the status and network LEDs for the Interface
Red LED Green LED
Off
Off
Off
Off
Off
Blinks 1x per 5
second interval
LED
Off
On
Flashing
On
Off
BIOS code failed to run.
Hardware POST failed. No firmware
images are loaded.
No CompactFlash disk or valid boot
sector image found.
Be sure to transfer the memory module
from the old card to the new card if the
Interface Manager was replaced.
Specified firmware image files were not
found. Neither the current nor the previous
image was found.
Load or execute command failed (boot
code remains at end of process). This
indicates that load, decompress, or
execution failed on both the current and
previous image files.
Normal state. Load or execute command
succeeded. Boot code successfully loaded,
decompressed, and initiated execution of
one of the image files.
Status
Port disconnected / no link
Port connected to another Ethernet device
Data is being transmitted / received
Port is operating at 100 Mbps
Port is operating at 10 Mbps, or port is
not connected (see Link Activity LED)
Maintenance and Troubleshooting
Description
Description
83