Icom IC-M32 Instruction Manual page 25

D Scan resume timer "St"
The scan resume timer can be set as a pause (OFF) or timer
scan (ON). When OFF is selected, the scan pauses until a
received signal disappears. When ON is selected, the scan
pauses for 5 sec. after receiving a signal and then resumes
even if the signal has been received.
Push
Scan resume timer OFF
(default)
D Auto scan function "AS"
The Auto scan function starts the desired scan automatically
when no signal is received, and no operation is performed
for 30 sec.
Push
Auto scan OFF (default)
D Dual/Tri-watch function "dt"
This item selects dual or tri-watch as desired. See p. 16 for
details.
D Monitor switch action "Sq"
Scan resume timer ON
The monitor switch action cuts off the squelch function tem-
porarily. This switch action contains PUSH (Pu) or HOLD
(Ho) settings as shown below.
• Pu (PUSH): After pushing the [SQL•
• Ho (HOLD): After pushing the [SQL•
Auto scan ON
Push
Dualwatch function
(default)
opens and emits audio. The squelch is held open
while continuously pushing and holding [SQL•
(default)
opens and emits audio even [SQL•
To close the squelch, push any key.
Push
Push setting (default)
7
SET MODE
Tri-watch function
] for 1 sec., the squelch
MONI
].
MONI
] for 1 sec., the squelch
MONI
] is released.
MONI
Hold setting
7
19