Cable Assembly (Step 3) - Hoist Fitness HD1400 Owner's Manual

NOTE: NOTE:
BE SURE CABLE RUNS BE SURE CABLE RUNS
BETWEEN THE PULLEY AND BETWEEN THE PULLEY AND
THE GUARD SHAFT. THE GUARD SHAFT.
CABLE BOLT MUST BE THREADED CABLE BOLT MUST BE THREADED
A MINIMUM OF 1/2" INTO ITS RECEIVER A MINIMUM OF 1/2" INTO ITS RECEIVER
WITH JAM NUT TIGHTENED SECURELY TO WITH JAM NUT TIGHTENED SECURELY TO
ENSURE PROPER CONNECTION. ENSURE PROPER CONNECTION.
FINE TUNING FINE TUNING
LOOSEN JAM NUT AND THREAD LOOSEN JAM NUT AND THREAD
BOLT IN/OUT TO GIVE THE CABLE BOLT IN/OUT TO GIVE THE CABLE
PROPER TENSION. RE-TIGHTEN PROPER TENSION. RE-TIGHTEN
WARNING: WARNING:
CR
JAM NUT. JAM NUT.
NOTE: NOTE:
BE SURE CABLE RUNS BE SURE CABLE RUNS
BETWEEN THE PULLEY AND BETWEEN THE PULLEY AND
THE GUARD BOLT. THE GUARD BOLT.
Hardware Descriptions
J - 3/8"-16 UNC x 3" Hex Bolt
K - 3/8"-16 UNC x 2 1/2" Hex Bolt
AB - 3/8" Flat Washer
BB - 3/8" Nylok Nut
CK - 1/2" Flanged Spacer
CL - 4 1/2" Pulley
CM - 11/16" Flanged Spacer
CR - Leg Extension/Curl Cable
DD - Quick Release Cable Lock
DF - 7/16" External Retaining Ring
182 7/8" (4645mm)