Thecus N0204 User Manual page 80

NOTE
Setting Up an Nsync Target on an Thecus IP storage Nsync Device
On the Nsync target server, the administrator of that server has to set up a user
account with a folder named "nsync" and grant write access.
1. On the Nsync server, add a user for Nsync source (ex. nsyncsource1). For
instructions on how to add a user on the Thecus IP storage, see Chapter 4:
User and Groups Authentication> Local User Configuration >
Users.
2. On the Nsync server, grant that user (ex. nsyncsource1) write access to the
nsync folder. For instructions on how to set up a folder's ACL, see
Chapter 4: Storage management> Shore Folder>
Control List (ACL).
3. Once this is done, the target server will start accepting Nsync tasks from
server using that ID and password.
‧ ‧ ‧ ‧ S etting Up an Nsync Target on another Device other than Thecus IP storage
If you selected "Legacy FTP
storage will use the FTP protocol to back up the share folder. On the external storage
device, make sure there is a folder named "nsync", and the Auth ID has writable
permission in that folder.
‧ ‧ ‧ ‧ D esignating Thecus IP storage as an Nsync Target
The Thecus IP storage can act as an Nsync server, enabling another Nsync-equipped
Thecus NAS at a remote location backup their files to this Thecus IP storage. From
the System Network menu, choose the Nsync Target item, and the Nsync
Target Server screen appears.
Nsync Target Server Setting
Item
Nsync Target Server
NOTE
Using "Native Rsync Server" to backup data to other Thecus NAS devices
needs to enable target server and setup a valid username and password
to grant access permission.
Server" when setting up your Nsync task, the Thecus IP
Description
Enable or Disable Nsync Target support.
To enable Nsync task to go thru firewall, you have to open port TCP/1194 on
your firewall in both directions.
80
Add
Folder Access