General - TOTALINE CPE230RF Owner's Manual

The 7-day, commercial, programmable thermostats maintain room tem-
perature by controlling the operation of your heating, cooling, and ventilation
system. Separate heating and cooling set points and auto-changeover capa-
bility allow you to program schedules for energy savings.
All thermostats allow up to 4 time/temperature settings to be programmed
per 24-hr period. Each thermostat stores programs for 7 independent days.
Batteries are required for operation. During power interruption (batteries re-
moved) the internal NEVERLOST™ memory stores configuration programs
for an unlimited time. The clock will need to be reset every time power is lost
(batteries removed).
The wall mounted or hand-held transmitter sends its signal to a receiver
installed near the HVAC unit. Each paired transmitter and receiver can be
given a separate house code for multiple thermostat applications. Up to
4 transmitters can send information to 1 receiver device.
If more than one transmitter is used with a single receiver, the transmitters
must be given different Unit ID Numbers. Only the transmitter with Unit ID
Number 1 may have a programmed schedule or be configured. All configu-
ration parameters are taken from the transmitter with Unit ID Number 1. Trans-
mitters with Unit ID Numbers 2, 3, and 4 cannot be programmed or config-
ured (except for set points).
When more than one transmitter is used, the receiver will only accept com-
mands from the transmitter that was last used (button pressed). All other set
points and modes from other transmitters are ignored. If the transmitter with
Unit ID Number 1 has a schedule and is in Program On mode, the receiver
will revert back to following the programmed schedule when a time period
change occurs, even if the transmitter with Unit ID Number 1 is not the cur-
rent commanding transmitter.
IMPORTANT: The transmitter has a configurable security level. If certain
functions are not available (changing set points, changing programming
schedules), the transmitter security level may be configured to exclude those
functions. Call the installer to reconfigure the security level.

GENERAL

2