Side Panel - Roland VC-1-SC Owner's Manual

Side Panel

1.
USB port
Connect a computer used for remote control (p. 24).
* Operating the VC-1-SC by remote control requires downloading of the dedicated software
(VC-1 RCS) and installing it on a computer. You can download the dedicated software from the
following Roland website.
http://www.rolandsystemsgroup.net/
2.
INPUT SELECT switch
Each press switches the input connector. Refer to "Setting the Operation Mode" (p. 25).
* If the switch is difficult to press, use the tip of a pen or other narrow object to press it.
3.
SCALING TYPE switch
Each press changes the screen aspect (scaling). Refer to "Setting the Operation Mode" (p. 25).
* If the switch is difficult to press, use the tip of a pen or other narrow object to press it.
4.
Mode switches (MODE SW)
These set the VC-1-SC's operation mode. Refer to "Setting the Operation Mode" (p. 25).
* Use the tip of a pen or similar object to change the setting of a switch.
5.
Cord hook
Use this to secure the AC Adaptor cord in place. Refer to "About Securing the Power Cord" (p. 11).
1 2 3 4
Panel Descriptions
5
15