Brakes - HYOSUNG Aquila Owner's Manual

◉ DRIVE CHAIN ADJUSTMENT
Chain adjust in the following way.
20~30mm
(1) Place the motorcycle on the jack or block.
(2) Loosen the axle nut
(3) Adjust the slack in the drive chain by adjuster
as the lock nut
and right.
(4) For alignment of the rear sprocket and the
front sprocket, there are reference mark
on the same position.
After aligning and adjusting the slack in the
drive chain to 20~30mm (0.79~1.18 in),
retighten the axle nut securely and perform a
final inspection.
CAUTION
The drive chain for this motorcycle is
made of the special material.
The chain should be replaced with a
428HO.
Use of another chain may lead to prema-
ture chain failure.
.
turning toward the left
CAUTION
The drive chain should be inspected every
time before riding.
Excessive chain slack could cause the
chain to come off the sprockets and result
in accident or serious engine damage.
WARNING
Be careful not to touch the muffler when it
is hot : a hot muffler can burn you.
◉ DRIVE CHAIN CLEANING AND OILING
If the drive chain become dirty, the drive chain
and the sprocket is wore easily.
This times, clean the drive chain with solvent
and oil every 1,000km with lubricating oil or
motor oil.
Properly operating the brake systems are vital to
safe riding. Be sure to perform the brake inspec-
tion requirements as schedules.
The brakes should be inspected at periodic
inspection by your authorized Hyosung dealer.
30

BRAKES