Internal Switches, Jumpers And Adjustments - Telex Audiocom BP-2002 Operating Instructions Manual

INTERNAL SWITCHES, JUMPERS AND ADJUSTMENTS

There are several internal switches, jumpers and an adjustment that affect
operation. These are described below. To gain access to the switches,
jumpers and the adjustment, disconnect all power and line connections.
Remove two screws from the top of each side and two screws from
bottom of each side. Switch, jumper and adjustment locations are shown
in Figure 2.
Figure 2. Internal Switches, Jumpers and Adjustments. Note, if you
have 9350-7749-000 board, figure 4 on page 19.
NOTE: Figure 2 shows a BP-2002 with the switches and jumpers in
their factory default positions (referenced in Table 2).
The SIDETONE adjustment is also accessible behind the screw that
holds the belt clip (callout 5 in Figure 1).
The functions of the internal switches and jumpers are described in
Table 3.
11