Connecting The Tv Signal Source - HP Getting Getting Started Manual

Connecting the TV Signal Source

Connect the signal source for the TV by using the
TV In coaxial connector or the composite/S-video In
connector.
Plug the connector of a coaxial cable from your TV
or from your TV cable into the TV/Cable Ant
connector on the back of the PC, and then turn the
connector to tighten it.
Or
Plug a cable into the S-video or composite video In
connector on the back of the PC; use an S-video
cable (not provided) or the composite video cable.
Plug the other end of the cable into your set-top box
or other device that is providing the signal source
for the TV.
You must also plug audio cables (not provided) from
your set-top box into the Audio In right (red)
connector and the Audio In left (white) connector on
the back of the PC, if you are using a set-top box
with S-video or composite video output.
Refer to "HP Media Center PC Front Connectors" on
page 5.
You must also connect the Remote Emitter cable if
you are using a set-top box. See "Connecting the
Remote Sensor" on page 15.
n
Location and number
of connectors may
vary by model.
Connecting the Television Signal
13