Advertisement
• Chronograph
Run chronograph
2. Once you have selected a feature mode, to change a setting in that
mode, hold the MODE button down for 2-3 seconds until the
display flashes.
When in 'Button Beep ON' mode (watch default), the Heart Rate Watch
will beep when the buttons are pushed.
3. Once flashing, to set a feature use the ST/STP (Start/Stop) button to
increase and RESET button to decrease the setting.
4. To move to the next setting, press and release the
MODE button.
5. To save new settings after completion, hold the MODE button
down for 2-3 seconds until the display stops flashing.
Setting Time
1. While in the Time mode hold the MODE button down for
2-3 seconds until the display flashes.
2. The 'seconds' display will flash. In order, the settings to
enter will be:
• seconds
• minutes
• hours
• 12Hr (am/pm) or 24Hr (military) time mode
• Button Beep ON or OFF (buttons beep when pressed
when ON, no beeping when OFF)
3. To set the feature, press the ST/STP (Start/Stop) button to increase
and RESET button to decrease the setting.
Advertisement
