Advertisement
Be sure to activate the Heart Rate mode by pressing the bottom metal
sensor so that the display flashes. It is best to use the flat 'pads' of your
finger, and not the fingertips.
3. A 'beep' will sound and your heart rate will be displayed.
It's that easy!
Because the Sportline Solo 900 Heart Rate Watch is a sensitive
monitoring device that reads your EKG signals, reading times will vary.
If you don't get a reading in 3-8 seconds, wait a couple of minutes and
try again. This gives the Sportline Solo 900 Heart Rate Watch a chance
to settle in and pick up your electrical signals.
Your heart rate will remain displayed once measured,
and will remain displayed for 7 seconds after you release
the sensor button.
• The Sportline Solo 900 Heart Rate Watch must be attached
to your wrist in order for the Heart Rate Measure function
to work.
• Proper finger pad contact is very important and affects the heart rate
reading time.
• For those users with dry skin, thick or calloused finger, low heart rate
signal strength (EKG strength), minimal padding
on your finger, or users located in dry environments, please see our
Helpful Hints section.
• The Heart Rate Measure function is not intended for use or operation
in or under water.
Advertisement
