Push Stick And Push Block; Auxiliary Fence - Skil 3310 Operating/Safety Instructions Manual

SM 2610008289 02-10:3310 Table Saw 2/2/10 8:38 AM Page 56

Push Stick and Push Block

Make the Push Stick 1 using a piece of 1 x 2 as shown (Fig. 35).
Make the Push Block 2 using pieces of 3/8" plywood 3 and 3/4"
hardwood 4 (Fig. 36).
The small piece of wood, 3/8" x 3/8" x 2-1/2", should be GLUED to
the plywood ... DO NOT USE NAILS. This is to prevent dulling the
sawblade in the event you mistakenly cut into the Push Block.
Position the handle in the center of the plywood and fasten
together with glue and woodscrews.

Auxiliary Fence

Make one using pieces of 3/8" plywood 3 and 3/4" hardwood 4.
Fasten together with glue and woodscrews (Fig. 37).
NOTE: Since the Push Block 2 is used with the Auxiliary Fence 5,
the 4-3/4" dimensions must be held identical on both the pieces.
FIG. 35
1-1/2"
1/4"
1/4"
1/4"
WORKPIECE
END
EXTRÉMITÉ
CONT CT VEC
L'OUVR GE
EXTREMO DE
L PIEZ DE
TR B JO
4-3/4"
12"
3/8"
2-1/2"
5-1/8"
THESE EDGES
MUST BE P R LLEL
CES BORDS DOIVENT
ÊTRE P R LLÈLES
ESTOS BORDES DEBEN
SER P R LELOS
3
THIS F CE ND
THIS EDGE MUST
BE P R LLEL
CETTE F CE ET CE
BORD DOIVENT ÊTRE
P R LLÈLES
EST C R Y ESTE
BORDE DEBEN SER
P R LELOS
NOTE: ll dimensions in inches.
REM RQUE : Toutes les dimensions sont en pouces.
NOT : Todas las dimensiones están en pulgadas.
56.
3/4"
15"
45° NOTCH
ENCOCHE À
45°
MUESC DE
45°
FIG. 36
4
12"
5"
2-1/2"
3/8" 3/8"
3
FIG. 37
4
1-3/4"
4-3/4"
19"
5-1/2"
1
2
5