Advertisement
Charging
*Your new battery cartridge
is
not charged.
You will need to charge it before use. Use
the fast charger Model DC1410 to charge
the battery cartridge.
*Plug the fast charger into the proper N C
voltage source. The charging light will flash
in green color.
*Insert the battery cartridge so that the plus
and minus terminals on the battery car-
tridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port so
that it rests on the charser ~ o r t floor.
~
1201 / 1201A
Charging light
-
Approx. 50 min.
-
I
*When the battery cartridge is inserted, the charging light color will change from green to
*When charging is completed, the charging light color will change from red to green.
*After charging, unplug the charger from the power source. Refer to the table below for
red and charging will begin. The charging light will remain lit steadily during charging.
the charging time.
1202 I 1 2 0 2 A / 1222
DC1410
Approx. 60 min.
I
1200
I
ADDrox. 4 0 min.
I
CAUTION:
*The fast charger Model DC1410 is for charging Makita battery cartridge. Never use it for
other purposes or for other manufacturer's batteries.
*When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time, it may not accept a full charge. This is normal condition and
does not indicate a problem, You can recharge the battery cartridge fully after discharging
it completely and recharging a couple of times.
*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has
been left in a location exposed to direct sunlight or heat for a long time, the charging light
may flash in red color. If this occurs, wait for a while. Charging will begin after the battery
cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge
from the fast charger.
*If the charging light flashes alternately in green and red color, a problem exists and charg-
ing is not possible. The terminals on the charger or battery cartridge are clogged with
dust or the battery cartridge is worn out or damaged.
*If you wish to charge two battery cartridge, allow 15 minutes between chargings on the
fast charger.
8
Advertisement
