Advertisement
Remote Printer Console Menu Table
Main menu
Sub menu
IBM
Font Number
Font Pitch/Point Size
Character Set
Auto LF
Auto CR
Auto Mask
Left Margin
Right Margin
Top Margin
Bottom Margin
Lines
Network
IP Address
Subnet Mask
Gateway
Interface
Auto Interface Timeout
Input Buffer (Level)
Parallel
USB 2.0 Hi-Speed
Options
The number of fonts available
vary by model.
Font Pitch: 0.1 to 576.0
Point Size: 0.25 to 999.75
The Symbol Set available will
vary by model.
on (CR → CR + LF)
off (CR → CR)
on (LF → LF + CR,
FF → FF + CR,
VT → VT + CR)
off (LF → LF,
FF → FF,
VT → VT)
off, on
xx column(s)
xx column(s)
0, 0.33, 0.5, 1.0, 1.5, 2.0
inches
0, 0.33, 0.5, 1.0, 1.5, 2.0
inches
xx line(s)
[000-255].[000-255].
[000-255].[000-255]
[000-255].[000-255].
[000-255].[000-255]
[000-255].[000-255].
[000-255].[000-255]
1 to 99 sec.
1 to 15
High-Speed
on, off
Bi-Dir
on, off
Input Prime
on, off
on, off
Descriptions
Selects the default font from the fonts list.
Selects the font pitch or point size.
Selects the symbol set.
Selects whether a line feed will happen
when the printer reaches the right margin.
Selects whether a carriage return will
happen when the printer position reaches
the right margin.
By selecting off, a line feed and carriage
return will happen when the printer position
reaches the bottom margin.
Sets the left margin at 10 cpi.
Sets the right margin at 10 cpi.
Selects the top margin at a distance from
the top edge of the paper.
Selects the bottom margin at a distance
from the bottom edge of the paper.
Sets the number of lines on each page.
Sets the IP Address.
Sets the Subnet Mask.
Sets the Gateway.
You need to set the time-out period for the
auto interface selection.
Increases or decreases the input buffer
capacity.
Turns high-speed parallel communication
ON or OFF.
Turns bi-directional parallel
communications ON or OFF.
Turns prime signal ON or OFF.
Turns High-Speed USB 2.0 communication
ON or OFF.
3
3 - 4
Advertisement
