Start Your Installation - Toshiba TFTST-76T-5A SERIES Owner's Manual

Installation

Start Your Installation

Connecting the Display(Figure 10.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector; plug one end of the AC power cord into the
power adapter, and the other end into an electrical outlet ( ).
3. For the PC with Analog output: Connect the VGA signal cable from display VGA input connector
to the 15-pin connector of your host computer and tighten the screws ( ).
4. Connect the Audio-In cable from audio input port of your display to the Audio-out port of your
computer ( ).
5. Connect the RS232 cable from RS232 port of your display to the RS232 port of your
computer( ).
6. Turn on your computer, display and video source.
Figure 10.1
Power Cord
Notice: To ensure the LCD Display will work well with your computer, please configure the display mode of your graphics
card to make it less than or equal to 1024 x 768 resolution and make sure the timing of the display mode is
compatible with the LCD screen. We have listed the "Compatibility Modes" of this LCD screen in appendices for your
reference.
VGA Cable
8
Audio-In
RS232 Cable
Cable
EO1-19041
Start Your Installation
ST-7000-WM-2E
ST-7000-WM-1C
ST-6501-C7