Lighting Instructions - Heat-N-Glo Gas Fireplace Owner's Manual

Lighting Your Standing Pilot Ignition Fireplace
Guide
do not
1. “STOP!” Read the safety information on page 9 first!
2. To access controls, open the lower grille.
3. Turn the gas control valve knob to the OFF
position. To do this, you must turn the knob
clockwise to the PILOT position, and
then press in and continue turning clockwise
to the OFF position.
GAS CONTROL VALVE MODELS
NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
4. WAIT AT LEAST FIVE (5) MINUTES TO CLEAR
OUT ANY GAS. If you have unsuccessfully tried to
light the fireplace, wait longer, especially if you are
using LP gas. Then smell for gas, including near
the floor. If you then smell gas, STOP! Follow "B"
in the safety information on page 6. If you don't
smell gas, go to the next step.
5. The pilot should not require accessing for lighting
purposes. The pilot is located inside the combustion
chamber. If it is necessary to access the pilot,
remove the trim door and glass door.
TO TURN OFF GAS APPLIANCE
1. Open the lower grille.
2. Set ON/OFF switch to “OFF”.

LIGHTING INSTRUCTIONS

STANDING PILOT CONTROLS
THERMOCOUPLE
6. To put the control in the PILOT position, turn the
control knob counter-clockwise
PILOT position.
7. To light the pilot press the control knob and then
press the red piezo button once every second.
The piezo makes a clicking sound. It may be
necessary to repeat this step. If the pilot does
not light after 10 seconds, go back to step 3. The
control knob should be held down for a MINUTE
after pilot ignition.
• If the control knob does not pop out when
released, STOP! Shut off the gas supply to the
fireplace control valve, and IMMEDIATELY call
your service technician or gas supplier.
• If the pilot will not stay lit after two tries, turn the
control knob to the “OFF” position and call your
service technician or gas supplier.
8. After the pilot has been lit, the burner can be
turned on by turning the knob counter-clockwise
9. Set the ON/OFF switch to the “ON” position.
10. Close the lower grille.
3. Turn the valve control knob clockwise
position, then depress knob and continue turning to “OFF” position.
4. Close the lower grille.
Owners
PILOT
THERMOPILE
to the
to the “ON” position.
to the “Pilot”