Extron electronics System 4LQ
xi User Manual page 17

Projector/Monitor Applications
_______ Because this manual is for the System 4 xi Series switchers, the name "System
Extron • System 4 xi Switcher Series • User's Manual
The System 4xi can be configured for most projectors. Some of the projector
manufacturers that Extron supports are:
• Ampro
• Barco
• Digital Projection
• Eiki
• Electrohome
• Epson
• Digital Projection
• Hughes/JVC
• Infocus
If your projector manufacturer is not on the above list, please consult your Extron
representative.
4 xi " will be used except when referring to a specific model.
The following diagram is a typical example of System 4xi-to-projector cabling.
However, before connecting the cables, verify that the System 4xi is already
configured for your projector/monitor.
Rear Panel
INPUT 1 INPUT 2
H/HV V H/HV V
AUDIO AUDIO
R/C G/Y B R/C G/Y B
Figure 2-2. System 4 xi Outputs. A factory label identifies the configuration.
Configuring the System 4xi for your application requires the following major steps
using the System 4 xi Projector Communications Kit instructions for your specific
projector or monitor:
Chapter 2 • Configuration and Installation
• Mitsubishi
• NEC
• Panasonic
• Seleco
• Sharp
• Sony
• Toshiba
• Zenith
INPUT 3 INPUT 4
H/HV V H/HV V
AUDIO AUDIO
R/C G/Y B R/C G/Y B
Projector Communication
Extension Cable
Projector
Comm Adapter
2-Channel
Stereo Audio
OUTPUT
PJ COMM
H/HV V
AUDIO
RS 232
R/C G/Y B
BNC Cable
Projector
2-2