Getting Started - Extron electronics System 4LQ
xi User Manual

System 4 xi Switcher Series

Getting Started..........

uu
tt
Step 1
If the System 4xi is already configured for your model of projector, go to Step 4 . If it is not set
up correctly, it will be necessary to change switch settings on the System 4xi 's Main
Controller Board. Continue with Step 2 below to verify the correct configuration.
uu
tt Step 2
Apply power to the System 4xi. Use the front panel to display the Information Menu (Menu 8).
If the configuration is correct, go to Step 4 . If it is not correct, continue with Step 3 .
uu
tt Step 3
Go to the procedure on page 2-3 of the System 4 xi User's Manual to remove the System 4xi
cover. Then go to page 2-4 for instructions on configuring the Main Controller board. The
following table and diagram are to be used only as examples of a typical configuration. Please
consult either the label inside the System 4xi top cover or the System 4 xi Projector
Communications Kit instructions for the correct configuration settings. Continue with Step 4
below when your configuration is correct.
Config Projector
as
Your Model
uu
tt
Step 4
Double-check your work and be sure the System 4xi cover is back on securely.
uu
tt Step 5
Please refer to the appropriate connection diagram for your projector (see your System 4 xi
Projector Communications Kit instructions). Using the appropriate Communications Adapter
included in your Communications Kit, connect the Comm extension cable from the PJ Comm
port of the System 4xi to the Comm Adapter. Secure the Comm Adapter to the appropriate
projector port.
uu
tt
Step 6
Connect the RGBS/HV cable from the System 4xi output BNC connectors to the projector's
matching RGBS/HV input connectors. Verify that all your connections are correct. If in
doubt, please refer to the specific installation instructions which were included in your
Communications Kit.
Extron • System 4 xi Switcher Series • User's Manual
SW1: 1-2-3-4 SW2
off-on-off-on 0
SW4
SW3
SW2
SW6
SW3 SW4 SW5 SW6
1 0 5 0
SW5
J15
SW1
Contents
Prj Cable Comm
Adapter
J15 26-467-01