Technical Data; Installation - Zanussi ZFU19400WA User Manual

3. If necessary, replace the defective door
gaskets. Contact the Service Center.

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry, well
ventilated indoor where the ambient tempera-
ture corresponds to the climate class indicated
on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for some
types of models when operating outside of that
range. The correct operation can only be guar-
anteed within the specified temperature range. If
you have any doubts regarding where to install
the appliance, please turn to the vendor, to our
customer service or to the nearest Service Cen-
tre
10
Height
Width
Depth
Rear spacers
In the bag with the documentation, there are
two spacers which must be fitted as shown in
the figure.
1. Fit the spacers
2. Turn counter-
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
into the holes.
Make sure that
the arrow (A) is
positioned as
shown in the pic-
ture.
clockwise the
spacers through
45° until they
lock into place.
A
45˚
www.zanussi.com