Environmental Concerns - Zanussi ZFU19400WA User Manual

1. Remove the plug
from the power socket.
2. Tilt back the appli-
ance carefully so that
the compressor can-
not touch the floor.
3. Unscrew both ad-
justable feet.
4. Unscrew the screws
of the door bottom
hinge.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.

Environmental concerns

Recycle the materials with the symbol
the packaging in applicable containers to
recycle it.
Help protect the environment and human health
and to recycle waste of electrical and electronic
12
2
1
5. Take off the appli-
ance door by pulling it
slightly downwards.
6. Unscrew the top
door hinge pin of the
appliance then screw
it back on the other
side.
7. Fit the appliance
door on the upper
door hinge pin.
. Put
8. Remove the lower
hinge. Put over the pin
in the direction of the
arrow.
9. Unscrew and install
the screw on the op-
posite side.
10. Install the lower
hinge on the opposite
side leaving the posi-
tion of the door un-
changed.
11. Screw in the one
screw in the place set
free on the other side
as well as the adjusta-
ble feet (2 pieces).
The appliance must be earthed. The power sup-
ply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is
not earthed, connect the appliance to a sepa-
rate earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
appliances. Do not dispose appliances marked
with the symbol with the household waste.
Return the product to your local recycling facility
or contact your municipal office.
12. Remove and install
1)
the handle on the
opposite side.
13. Reposition, level
the appliance, wait for
at least four hours and
then connect it to the
power socket.
www.zanussi.com