Advertisement
You can read the recommendations in the user guide, the technical guide or the installation guide for CREDA HBW810. You'll find
the answers to all your questions on the CREDA HBW810 in the user manual (information, specifications, safety advice, size,
accessories, etc.). Detailed instructions for use are in the User's Guide.
User manual CREDA HBW810
User guide CREDA HBW810
Operating instructions CREDA HBW810
Instructions for use CREDA HBW810
Instruction manual CREDA HBW810
You're reading an excerpt. Click here to read official CREDA
HBW810 user guide
http://somemanuals.com/dref/16895
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Creda W810
Summary of Contents for Creda W810
- Page 1 You can read the recommendations in the user guide, the technical guide or the installation guide for CREDA HBW810. You'll find the answers to all your questions on the CREDA HBW810 in the user manual (information, specifications, safety advice, size, accessories, etc.).
- Page 2 To the Installer Before installation fill in the product details on the back cover of this booklet. The information can be found on the rating plate. To the User You must read the instructions prior to using the appliance and then retain them for future reference. FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 2 CONTENTS Introduction For Your Safety Always For Your Safety Never Using The Hob Care &...
- Page 3 Never use water to extinguish oil or fat fires 4 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 5 FOR YOUR SAFETY NEVER q q q q q q q q q q q q q Never leave children unsupervised where a cooking appliance is installed as all cooking surfaces will be hot during and after use. Never allow anyone to sit or stand on any part of the appliance.
- Page 4 Never use scouring pads or abrasive cleaners/powders which may scratch the surface. BURNER ASSEMBLY 7 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 8 SOMETHING WRONG ? IF THE IGNITION DOES NOT WORK Is the electricity switched on? If the electricity supply has failed, the burners can be lit with a match.
- Page 5 Make sure that the cable does not become trapped. 9 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 10 INSTALLATION INSTRUCTIONS Gas Category II2H3+ (GB,IE) Model Numbers W810, BG05 These models are set to burn NATURAL GAS (G20) at 20mbar. They can also be converted to burn BUTANE GAS (G30) at 28mbar or PROPANE GAS (G31) at 37mbar using the conversion kit included.
- Page 6 3). Turn each gas tap bypass screw fully clockwise using a small flat bladed screwdriver through the holes in the control panel. The bypass screw is located to the side of the tap spindle (Fig.4). 14 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 15 15 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 16 Key Contacts Service Creda has the largest appliance manufacturer's service team in Europe, trained specialists directly employed by us to ensure your complete confidence.
Need help?
Do you have a question about the W810 and is the answer not in the manual?
Questions and answers