Subscribe to Our Youtube Channel
Related Manuals for Creda D900E
Summary of Contents for Creda D900E
- Page 1 Instructions for Installation and Use Ceramic Hobs Note: Ensure that the hob unit is securely fixed to the worktop before use. To the User You must read the instructions prior to using the appliance and then retain them for future reference.
- Page 2 For more information on our exciting product range ring Creda Answer Centre 08701 54 64 74 Visit us on the NET at http://www.creda.co.uk interactive cookbook product selector. Our site invites you to make use of our Feel browse our product range...
-
Page 3: Table Of Contents
Contents Introduction ...........4 Safety Information . -
Page 4: Introduction
Introduction Your new appliance is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully. The appliance is designed specifically for domestic use and responsibility will not be accepted for use in any other installation. -
Page 5: Safety Information
Safety Information When used properly your appliance is completely safe but as with any electrical product there are certain precautions that must be observed. PLEASE READ THE PRECAUTIONS BELOW BEFORE USING YOUR APPLIANCE. Always Remove all packing from the appliance before switching on for the first time. Understand the controls prior to using the appliance. - Page 6 Safety Information Never Never leave children unsupervised where a cooking appliance is installed as all surfaces will be hot during and after its use. Never allow anyone to sit or stand on any part of the appliance. Never store items above the appliance that children may attempt to reach. Never leave anything on the hob surface when unattended and not in use.
-
Page 7: Using Your Hob
Using Your Hob Choice Of Utensils Every Electric Hob deserves the right choice of utensils. We recommend for optimum performance the use of good quality utensils. Always Never PANS SHOULD NOT: Use good quality flat-based Use gauze, metal pan diffusers, cookware on all electric heat asbestos mats and stands e.g. - Page 8 Using Your Hob THE BEST COMBINATIONS This table is a general guide to the types of pan suitable for different types of hobs and cookers. Remember pans should be good quality, with smooth, flat bases. For any further information refer to manufacturers’ instructions. Saucepan Types Suitability Aluminium...
- Page 9 Using Your Hob NEVER allow aluminium foil to be in contact with the hob surface when in use. Setting the Hotplate Step 1 Place the saucepan centrally on the required hotplate. Step 2 Turn the associated hotplate control to the required setting. Step 3 When you have finished, turn the hotplate control knob to the OFF position O.
- Page 10 This illuminates when any control is switched on and remains illuminated for some time after switching the control off. Creda Hob Units - Features The rating plate for all models is situated on the underside of the base panel.
- Page 11 Using Your Hob Model No. E920E R920E 42354 42355 42399 Heating Areas: (1) 1.2kW Solarglo (2) 1.8kW Solarglo (3) 1.2kW Solarglo (4) 1.8kW Solarglo 230 - 240V ~ 5.5 - 6.0 kW 50Hz Solarglo Models Solarglo ceramic heaters give a faster response than the ordinary heating areas. Model No.
-
Page 12: Something Wrong
Something Wrong ? Before contacting your Creda Service Centre / Installer, check the following; there may be nothing wrong with your appliance. CHECK PROBLEM Is the main wall switch to the cooker turned on ?. -
Page 13: Care And Cleaning
Care And Cleaning SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CLEANING.BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION. NEVER USE BIOLOGICAL WASHING POWDER, HARSH ABRASIVE, SCOURING PADS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS OF ANY KIND. Cleaning Materials To Avoid 1. -
Page 14: Installation
Installation WARNING - THIS APPLIANCE MUST BE EARTHED All Creda hobs are suitable for installation over any Creda Build-in or Build-Under Ovens. Your hob should have been checked to ensure that the voltage corresponds with your voltage supply. This is stated on the rating plate, which is situated on the under side of the base panel. The appliance must be connected by a contractor/engineer such as one who is registered with the National Inspection Council for Electrical Installation Contracting (NICEIC). -
Page 15: Installation
Installation FITTING THE HOB Unpack the hob from the carton. Remove the bag containing the sealing tape, fixing brackets and screws. Fit the sealing tape to the underside of the hob close to the edge. Lower the hob into the worktop ensuring the mains lead is fed into the base unit and is not trapped under the flanges. -
Page 16: Service
08701 54 64 74 For further product information All Creda Services are offered as an extra benefit and do not affect your statutory rights. General Domestic Appliances Limited, Morley Way, Peterborough, PE2 9JB PRINTED BY: SIMLEX . FOUR ASHES, WOLVERHAMPTON...
Need help?
Do you have a question about the D900E and is the answer not in the manual?
Questions and answers
how to restart clock after electric failure