Init Display First; Reset Configuration Data - LanParty P45 Series User Manual

PnP/PCI Configurations
This section describes configuring the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.

Init Display First

Reset Configuration Data

Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
**PCI Express Relative Items**
Maximum Payload Size
↑↓→←
: Move
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.
Init Display First
This field is used to select whether to initialize the onboard VGA, PCI
Express or PCI first when the system boots.
Onboard
PCIEx
PCI Slot
Reset Configuration Data
Enabled
Disabled
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
128
Enter: Select +/-/PU/PD: Value
F6: Fail-Safe Defaults
When the system boots, it will first initialize the
onboard VGA.
When the system boots, it will first initialize the
PCI Express x16 graphics card.
When the system boots, it will first initialize PCI.
The BIOS will automatically reset the Extended
System Configuration Data (ESCD) once. It will
then recreate a new set of configuration data.
The BIOS will not reset the configuration data.
BIOS Setup
Item Help
Menu Level
F10: Save ESC: Exit F1: General Help
F7: Optimized Defaults
3
7 5