Speaker assembly
Description
Speaker assembly (includes cable)
Before removing the speaker assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service cover (see
b.
Optical drive (see
c.
Hard drive (see
d.
Modem module (see
e.
Keyboard (see
f.
Base enclosure (see
Remove the speaker assembly:
1.
Turn the base enclosure right-side up, with the front toward you.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the speaker assembly to the
base enclosure.
84
Chapter 4 Removal and replacement procedures
Battery on page
55), and then remove the following components:
Service cover on page
Optical drive on page
Hard drive on page
62)
Modem module on page
Keyboard on page
76)
Base enclosure on page
57)
58)
73)
80)
Spare part number
641840-001