Making Sure The Unit Is Stable; Breaking In The Equipment - Precor P30 Operating And Maintaining

26

Making Sure the Unit Is Stable

Make sure the unit is level before allowing anyone to use it.
CAUTION: To eliminate movement, make sure the adjustable feet
are in contact with the floor.
To level the unit:
1.
2. Correct the height of each adjustable foot as follows.
Important: Place the unit on a flat surface. Rotating the
adjustable feet cannot compensate for extremely uneven surfaces.
When you are finished adjusting the unit, place the unit on the
floor and recheck that it is level.

Breaking in the Equipment

Precor equipment does not require an actual break-in period.
However, moving components such as belts, gears, and
bearings can settle while the equipment is being stored or
shipped. This can cause the equipment to operate with a
small amount of roughness or noise when it starts up for the
first time.
The equipment usually returns to smooth operation after a
day or two of normal use. If it does not, contact your dealer
for assistance. For more information, refer to Obtaining
Service.
Assembling and Maintaining UBK 800-Series Upright Exercise Bikes
Gently rock the unit. If there is any movement, ask your
assistant to tip the unit to one side while you locate the
adjustable feet.
If you want to ... Then turn the adjustable feet ...
Raise the unit Counterclockwise
Lower the unit Clockwise