Completing The Console Installation (P30 And P20); Verifying That The Heart Rate Display Is Operational - Precor P30 Operating And Maintaining

Installing the Console
Completing the Console Installation (P30
and P20)
Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
To complete the installation:
1.
2. Tilt the control console backward (toward yourself) until
3. Insert the four ⁵₈-inch flat head screws through the holes
4. Line up the two small tabs at the bottom of the console's
5. Insert the two #8–32 x ¹₂-inch Phillips-head screws that
6. Fully tighten the four mounting screws (partially
Verifying That the Heart Rate Display Is
Operational
To verify that the heart rate display is operational:
1.
2. Grasp both touch-sensitive handlebars.
3. Look at the HEART RATE display. After a few seconds, a
4. If a number does not appear in the HEART RATE display,
Feed extra cable back into the neck tube.
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
in the console mount and thread them into the holes in
the back plate on the console. Partially tighten the screws
using a ⁵₈-inch hex wrench.
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
you removed earlier into the holes at the top edge of the
console's back cover. Tighten the screws fully.
Important: Use caution not to pinch the cables between the
back cover and PVS mounting screw heads.
tightened in step 3) using a ⁵₃₂-inch hex wrench.
Begin exercising on the equipment.
Note: The heart rate is read within ten seconds. During
that time, the heart on the display flashes.
number appears indicating your heart rate.
check the cable connection to make sure it is properly
connected.
33