Removal/Installation; Removal; Installation - Precor R40 Service Manual

Removal/Installation

Removal

1. Remove the 4 R40 console attachment screws and tilt the console away from the Console Attachment bracket
2. Disconnect the 4 console-base cables and remove the Cable Retainer.
3. Remove the console.

Installation

Carefully connect and route the 4 console cables
1. Insert the stop switch cable (1) with the two connector tabs pointing down.
You will feel the cable lock into place.
2. Insert the base unit data cable (2).
When both cables are connected, tuck the cables into the left side of the cable retainer (5), as shown
in the figure below.
3. Insert the console ground cable (3) with the round side positioned upward
4. Insert the touch heart rate cable (4) with the front two tabs pointing down
5. When both cables are connected, tuck the cables into the right side of the cable retainer (5).
Important: Make sure that all four cables are tucked into the cable retainer before
you place the console on the bracket. Place excess cable in the console recess where
the cables insert.
Page 15