Display Assembly - HP PAVILION TX2500 Maintenance And Service Manual

Display assembly

Description
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, fingerprint
reader, microphones, and WLAN antenna cables
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, microphones,
and WLAN antenna cables
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the memory module compartment cover (see
6. Remove the WLAN module compartment cover and disconnect the wireless antenna cables from
the WLAN module (see
7. Remove the keyboard (see
8. Remove the switch cover (see
Remove the display assembly:
1. Close the computer and turn it upside down, with the front toward you.
2. Loosen the Phillips PM2.0×5.0 captive screw (1) that secures the display connector cover to the
computer.
3. Lift the rear edge of the display connector cover (2) and swing it toward you.
4. Remove the display connector cover.
NOTE:
487926-001.
Battery on page
WLAN module on page
Keyboard on page
Switch cover on page
The display connector cover is included in the Plastics Kit, spare part number
39).
Memory module on page
46).
49).
51).
Component replacement procedures
Spare part number
484751-001
484750-001
44).
53