Display - HP PAVILION TX2500 Maintenance And Service Manual

Display

WARNING!
handling the backlight to avoid damaging this component and causing exposure to the mercury.
CAUTION:
components intended for recycling purposes are the liquid crystal display (LCD) panel and the backlight.
Careful handling should be exercised when removing these components.
NOTE: Materials Disposal. This HP product contains mercury in the backlight in the display assembly
that might require special handling at end-of-life. Disposal of mercury may be regulated because of
environmental considerations. For disposal or recycling information, contact your local authorities, or
see the Electronic Industries Alliance (EIA) Web site at http://www.eiae.org.
This section provides disassembly instructions for the display assembly. The display assembly must be
disassembled to gain access to the backlight (1) and the liquid crystal display (LCD) panel (2).
NOTE: The procedures provided in this appendix are general disassembly instructions. Specific
details, such as screw sizes, quantities, and locations, and component shapes and sizes, can vary from
one computer model to another.
Perform the following steps to disassemble the display assembly:
1. Remove all screw covers (1) and screws (2) that secure the display bezel to the display assembly.
2. Lift up and out on the left and right inside edges (1) and the top and bottom inside edges (2) of the
display bezel until the bezel disengages from the display assembly.
108 Chapter 11 Recycling
The backlight contains mercury. Caution should be exercised when removing and
The procedures in this appendix can result in damage to display components. The only