Table of Contents
Advertisement
Troubleshooting guide
PROBLEM
CAUSE & REMEDY
The unit does not work,
and/or I cannot remove the
tape from the unit.
-Plug in the AC adaptor again.
The answering system is on
but no incoming messages
are recorded.
-The REC TIME selector is set to the
GREETING ONLY position. Change
it to the VOX or 1 MIN position.
-The greeting message is recorded
improperly or not recorded, so no
one can leave a message. Check
and record a new greeting message.
The call counter shows "Err". -The greeting message tape is not
inserted. Insert the tape.
-The greeting message tape might
be broken. Replace it with a new
one'
6 quick beeps sound during
greeting message recording,
and it results in failure.
-Re-record your greeting message.
Speak clearly and loudly, and do not
pause for over 5 seconds while
recording.
When a message is played
back, the sound level is low,
even if the volume is high.
-Clean the heads. (See page 45.)
-Replace the incoming message
tape with a new one.
The unit does not answer
remotely.
-The answering system is turned off.
To set the unit to answer the call,
call your unit and wait for 15 rings.
(See page 38.)
- 4 3 -
Advertisement
Table of Contents
