Power Connector Cable - HP PAVILION DV6 Maintenance And Service Manual

Removal and replacement procedures
Remove the USB board:
1. Disconnect the USB board cable 1 from the LIF connector on the system board.
2. Remove the Phillips PM2.5×6.5 screw 2 that secures the USB board to the base enclosure.
3. Remove the USB board 3 from the base enclosure.
Reverse this procedure to install the USB board.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover and keyboard (see
d. Display assembly (see
e. Top cover (see
f. USB board (see
g. System board (see
Remove the power connector cable:
4–36
"Battery" on page
"Hard drive" on page 4-14)
"Optical drive" on page
"Switch cover and keyboard" on page
"Display assembly" on page
"Top cover" on page 4-30).
"USB board" on page 4-35)
"System board" on page
4-6).
4-9)
4-24)
4-37)
Spare part number
533465-001
4-18)
Maintenance and Service Guide