Maxtor D740X-6L 20.0 AT Product Manual page 46

S p e c i f i c a t i o n s
   / ' % * # 0 + % # .
Maxtor D740X-6L hard disk drives are designed to meet the form factor dimensions
of the SFF committee specification SFF8300.
Height: 25.4 mm maximum
Width: 101.6 ± 0.25mm
Depth: 147.0 mm maximum
Weight: 1.3 lb
   ' 0 8 + 4 1 0 / ' 0 6 # . % 1 0 & + 6 + 1 0 5
Table 4-7 summarizes the environmental specifications of the Maxtor D740X-6L
hard disk drives.
2 # 4 # / ' 6 ' 4
Temperature
1
(Non-condensing)
Temperature Gradient
(Non-condensing)
Humidity (Non-condensing)
2
Maximum Wet Bulb
Temperature
Humidity Gradient
Altitude
3 , 4
Altitude Gradient
1. Maximum operating temperature must not exceed the drive at any point along
the drive form factor envelope. Airflow or other means must be used as needed
to meet this requirement.
2. The humidity range shown is applicable for temperatures whose combination
does not result in condensation in violation of the wet bulb specifications.
3. Altitude is relative to sea level.
4. The specified drive uncorrectable error rate will not be exceeded over these
conditions.
4 - 8 M a x t o r D 7 4 0 X - 6 L 2 0 . 0 / 4 0 . 0 / 6 0 . 0 / 8 0 . 0 G B A T
Environmental Specifications
6 C D N G  
1 2 ' 4 # 6 + 0 )
5° to 55°C
(41° to 131°F)
20°C/hr maximum
(68°F/hr)
10% to 85% RH
30°C (86°F)
10% / hour
–200m to 3,000m
(–650 to 10,000ft.)
1.5 kPa/min
0 1 0 1 2 ' 4 # 6 + 0 )
-40° to 65°C
(-40° to 149°F)
30°C/hr maximum
(86°F/hr)
5% to 95% RH
40°C (104°F)
10% / hour
–200m to 12,000m
(–650 to 40,000ft.)
8 kPa/min