Maxtor D740X-6L 20.0 AT Product Manual page 33

       % Q P P G E V K P I V J G # F C R V G T $ Q C T F C P F V J G & T K X G
Use a 40-pin ribbon cable to connect the drive to the board. See Figure 3-10. To
connect the drive to the board:
I n s e r t t h e 4 0 - p i n c a b l e c o n n e c t o r i n t o t h e m a t i n g c o n n e c t o r o f t h e a d a p t e r
1 .
b o a r d . M a k e s u r e t h a t p i n 1 o f t h e c o n n e c t o r m a t c h e s w i t h p i n 1 o n t h e c a b l e .
2. Insert the other end of the cable into the header on the drive. When
inserting this end of the cable, make sure that pin 1 of the cable connects to
pin 1 of the drive connector.
3. Secure the drive to the system chassis by using the mounting screws, as
shown in Figure 3-11.
( K I W T G    Drive Power Supply and ATA Bus Interface Cables
Maxtor D740X-6L 20.0/40.0/60.0/80.0GB AT
Installation
3-15