Memory Module - HP Compaq Mini 700 Maintenance And Service Manual

Memory module

Description
512-MB (PC2-4200, 533-MHz, DDR2)
1024-MB (PC2-4200, 533-MHz, DDR2)
2048-MB (PC2-4200, 533-MHz, DDR2) (HP Mini 1000 only)
Before removing the memory module, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
Remove the memory module:
1. Slide the right battery release latch to the inside or "unlocked" position to reveal the release latch
for the memory module compartment cover. Use a thin, narrow tool to slide the release latch to the
outside or "unlocked" position (1). (The edge of the cover rises away from the device.)
2. Remove the cover (2). The memory module compartment cover is included in the Plastics Kit, spare
part number 512192-001 for the red-colored HP Mini 1000 or 507317-001 for all other models of
the HP Mini 1000 and the Compaq Mini 700.
3. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the device.)
38 Chapter 4 Removal and replacement procedures
Battery on page 37).
Spare part number
504599-001
504600-001
517577-001