Table of Contents
Advertisement
5.
Open the device as far as possible.
6.
Remove the Phillips PM2.0×4.5 screw (1) and the Phillips PM2.5×5.0 screw (2) that secure the top
cover to the base enclosure.
7.
Lift the rear edge of the top cover (1) and swing it up. Then slide the top cover back slightly to rest
against the display assembly (2) at an angle.
8.
Release the ZIF connector (1) to which the TouchPad button board cable is connected.
46
Chapter 4 Removal and replacement procedures
Hide quick links:
Advertisement
Table of Contents
