Activating The Room Monitor And Entering The Number To Be Called - Siemens Dualphone DP45 Operating Manual

When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringtone and are only
shown on the screen. The display and
keypad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the
duration of the call, but the function
remains activated.
If you switch off the handset, the room
monitor mode is deactivated. You must
reactivate the function after switching on
the handset again.
Caution!
– You should always check the operation of
the room monitor before use. For example,
test its sensitivity. Check the connection if
you are diverting the room monitor to an
outside number.
– When the function is switched on the
handset's operating time is severely
reduced. If necessary, place the handset in
the charging cradle. This ensures that the
batteries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an
activated answering machine.
Activating the room monitor and
entering the number to be called
¢ ¢
v í
Room Monitor
¤
Change multiple line input:
Room M.:
On
Select to activate.
Call to:
Press the display key
destination number.
External number: select number from
the directory or enter directly. Only the
last 4 digits are displayed.
Internal number: delete any stored
external number.
§Edit§
and enter
s (select hand-
§INT§
Call All, if all registered handsets
set or
are to be called) §OK§.
Save numbers with §Save§.
Level:
Set noise level sensitivity
¤
Save changes (page 22).
The function is now activated. With v,
you can move directly to settings.
Changing previously set external
destination number
¢ ¢
v í
Room Monitor
s
Scroll to the
§Edit§
Press the display key.
˜
Delete existing number.
¤
Enter number as described in "Activat-
ing the room monitor and entering the
number to be called" (page 13).
¤
Save changes (page 22).
Changing previously set internal
destination number
¢ ¢
v í
Room Monitor
s
Scroll to the
§Edit§
Press the display key.
§Yes§
Press the display key to
confirm the prompt.
¤
Enter number as described in "Activat-
ing the room monitor and entering the
number to be called" (page 13).
¤
Save changes (page 22).
Deactivating the room monitor
remotely
Requirements: The phone must support
touch tone dialling and the room monitor
is set for an external destination number.
¤
Take the call from the room monitor
and press keys 9 #.
The room monitor function will deactivate
after the call ends. There will be no further
room monitor calls. The other room moni-
tor settings on the handset (e.g. no ring-
Menu tree
or High).
(Low
Call to:
line.
Call to:
line.
13