Table of Contents
Advertisement
TARGET IDENTIFICATION
In DISCRIMINATION Mode, targets are identified both audibly and visually as
follows:
1. Different pitch tones for different types of metals
2. A 2-digit Target ID
3. An illuminated icon within the target category best describing it
AUDIO TARGET IDENTIFICATION:
Tones identify targets as follows:
LOW TONE (ID: 1-39)
Ferrous objects, such as iron and steel, like nails and tin cans.
Smallest-sized gold objects and some steel bottle caps
MEDIUM TONE (ID: 40-79)
Foil, pull-tabs (some new style), nickels, steel bottle caps.
Newer pennies (post-1982 are minted from zinc)
Larger gold pieces, small brass objects, and most bottle screw caps.
Most recent-vintage non-US coins.
Pull-tabs (old style, some new style)
HIGH TONE (ID: 80-99)
Silver and copper coins, large brass objects
Older pennies (pre-1982 were minted from copper)
Dimes, quarters, half-dollars, silver dollars
Susan B. Anthony and Sacajawea dollar coins
Flattened aluminum cans (with a stronger signal than a coin)
MEDIUM TONE
LOW TONE
Pull Tabs, Nickels, Smaller &
Larger Gold, Zinc Pennies
Nails & Small Gold
(Post 1982), Many screw caps
Audio Target Identification (ATI) classifies metals into three categories.
16
ASSEMBLY
G
G
G
G
G
G
G
G
G
G
1 0
G
HIGH TONE
Copper, Silver & Brass
Copper Pennies (Pre 1982)
G
1 2
Caution:
Forcing in MIDDLE STEM with CAM LOCK raised may form a burr on
camlock. If this happens, remove burr with knife to allow insertion.
Position S-Rod upright.
1
Rotate the LOCKING COLLAR fully in the
2
counterclockwise direction.
Insert your finger inside the tube and make sure the
3
INTERNAL CAM LOCK is flush with the inside of the tube.
LOCKING
COLLAR
SILVER BUTTON
S-ROD
S-ROD
MIDDLE STEM
G
5
Insert the MIDDLE STEM into the S-ROD,
4
with the SILVER BUTTON pointed upward
Rotate the MIDDLE STEM until the SILVER BUTTON
5
locates in the hole.
Twist the LOCKING COLLAR fully in the clockwise
6
direction until it locks.
7
Repeat this process on the LOWER STEM.
Using the BOLT and KNURLED KNOB, attach the
8
SEARCHCOIL to the LOWER STEM.
Adjust the LOWER STEM to a length that lets you maintain
9
a comfortable upright posture, with your arm relaxed at your
side, and the SEARCHCOIL parallel to the ground in front of
you.
Wind the CABLE securely around the STEMS.
Connect CABLE PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking Ring only.
Use minimal finger pressure to start the threads. Do
not cross-thread. When the Locking Ring is fully
engaged over the threaded connector, give it a firm
turn to make sure that it is very tight. When the
Locking Ring is fully engaged over the threaded
connector, it may not cover all of the threads.
Tighten both LOCKING COLLARS.
*
Note: Very tall users can purchase the optional Extended Lower Stem (TUBE5X), for extended reach.
G
2
INTERNAL
G
3
CAM LOCK
MIDDLE
G
4
STEM
G
4
5
Advertisement
Table of Contents
