Battery Connector Board - HP ENVY 14 Maintenance And Service Manual

Battery connector board

Description
Battery connector board (includes cable)
Before removing the battery connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery cover and battery (see
5. Remove the memory module/wireless module compartment cover (see
on page
Remove the battery connector board:
1. Remove the plastic cover (1) located at the base of the accessory battery connector.
2. Remove the two Phillips PM2.5×3.86 screws (2) and the three Phillips PM2.0×2.83 screws (3)
that secure the battery charger board to the base enclosure.
3. Release the zero insertion force (ZIF) connector to which the battery charger board cable is
connected, and then disconnect the cable (4) from the connector.
41).
Battery on page 36).
Component replacement procedures
Spare part number
654172-001
WLAN module
47