Zanussi ZDF2021 User Manual page 6

German
degrees
(°dH)
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Electronic adjustment
The appliance must be in setting mode.
Refer to 'SETTING AND STARTING A
PROGRAMME'.
1. Make sure that the programme marker on
the programme knob is aligned with the off
position.
2. Press and hold Start. At the same time
turn the programme knob counterclock-
wise until the programme marker is aligned
with the first programme on the control
panel.
3. Release Start when the display shows the
setting of the water softener.
• Example:
4. Press Start again and again to change the
setting.
5. To confirm the setting, turn the programme
knob until the programme marker is aligned
with the off position.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
6
Water hardness
French
degrees
(°fH)
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
= level 5.
mmol/l Clarke
degrees
13 - 17
5 - 12
< 0.7
1
3
Put 1 litre of water in
the salt container
(only for the first
time).
5
Water softener
adjustment
< 5
2
4
6
www.zanussi.com
Level
3
2
2)
1